Mcube CubeScan BioCon-500 Service Training page 33

3. System Setup 3. System Setup 3. System Setup 3. System Setup
Calibration Error Code
Error Error
Error Error
Code Code
Code Code
7 Error in the Analog Board
If there's no reflection signal from
8
target.
9 Error in the direction of the angle
motor rotation
10 Variation in the angle motor start
position
www.mcubetech.co.kr
Description Description
Description Description
Check the Analog Board
Probe is not in the CalKit.
Check the angle motor
Check probe connection
Check the angle motor
Check probe connection
-33-
Remark Remark
Remark Remark