Table of Contents
Advertisement
70 Chapter 3 Setting up the Nortel VPN Router 1010, 1050, and 1100
•
DHCP instructions
If your ISP uses DHCP to assign an IP address to your PCs, verify that your VPN
Router is connected to the Internet and start the quick-start tool as follows:
1
2
3
4
5
PPPoE instructions
If your ISP uses PPPoE to assign an IP address to your PCs, connect the VPN
Router to the Internet and then start the quick-start tool as follows:
1
2
3
4
5
NN46110-500
If your ISP uses static IP addressing, go to
page
71."
Note: If you complete the steps in the appropriate section and your VPN
Router is not up and running, contact the service provider or company
that provided the VPN Router.
Start your Web browser to verify connectivity to the Internet. (By default, the
LAN 1 port on the VPN Router acts as a DHCP client and receives an IP
address from the public side.)
Locate the provisioning worksheet sent by the company or provider that sent
you the VPN Router.
Enter the following URL in your browser window: http://192.168.1.2/
manage/qs.pyc.
Click on Manage Switch, and then type admin and setup as the user name
and password.
Follow the instructions on the window that appears.
Open a Web browser and enter the following URL in the browser window:
http://192.168.1.2.
Click on Manage Switch, and then type admin and setup as the user name
and password.
From the menu bar, choose System > LAN to display the LAN Interfaces
window and select Cancel Acquisition.
From the Select Protocol list, choose PPPoE and click on Apply.
The Add PPPoE Interface window appears.
"Static IP instructions" on
Advertisement
Table of Contents
