Konica Minolta AccurioPress C6100 Operation Manual page 80

9.1 If an Out-of-Range Image is Detected
No. Status
6 Message "Too Many
Stains" is displayed on
the bookmark of the out-
of-range image report.
Message "Position Error
(Scan)" is displayed as
error information on the
out-of-range image re-
port.
Message "Barcode/
No.Mis." is displayed as
error information on the
out-of-range image re-
port.
Message "CSV Unfit" is
displayed as error infor-
mation on the out-of-
range image report.
7 Message "Inspection
failed" is displayed on
the control panel.
Automatic Inspection Operation Manual
Cause
One hundred or more
stains, which is in the
standard, were detected.
(Such stains are not out
of range, so a comment
marked by a red circle is
not displayed.)
A large stain is found on
an image.
The target image, for ex-
ample, a pale image or a
simple image made up of
ruled lines only, is diffi-
cult to align.
The printing position is
misaligned by 2.5 mm or
more.
Paper is different be-
tween the reference im-
age and the actual print.
The contents of the
source CSV file are dif-
ferent from the printing
result.
The settings of the type
or orientation of the in-
spection area, the bar-
code type, and more are
different.
The specified page is not
found in the source CSV
file.
The specified coordi-
nates are different in the
source CSV file.
The specified setting val-
ue is different in the
source CSV file.
The paper size is differ-
ent between the refer-
ence image and the print
job.
Remedy
Stains may be seen in the paper feed-
ing route. Perform maintenance for this
machine.
For details, refer to [Perform mainte-
nance] or [Adjustments] in the HTML
User's Guide.
If any stain is found on the reference
image, create a reference image again.
If any stain is found on printouts, per-
form automatic inspection again after
carrying out maintenance of this ma-
chine.
Set Inspection Excluding Area to the
entire surface of the page in which an
error frequently occurs.
Check the paper loaded in the tray.
Load the paper that is used to create a
reference image.
Otherwise, load the paper you want to
actually use, and create a reference im-
age again.
Check the inspection data and decod-
ing results (CSV file in the report).
Also, check whether the barcode area
or serial No. (0-9) area is set based on
the specifications.
For details, refer to "7. Automatic In-
spection Area" in this manual.
Check the inspection data and the CSV
file in the report.
Check whether the print job matches
the reference image. If no problems are
identified, create a reference image
again.
9
9-3