Konica Minolta AccurioPress C6100 Operation Manual page 18

2.2 Checking the Automatic Inspection Level
1
Set the details of automatic inspection.
Determine the basic settings and operation settings for automatic inspection. For details on the set-
tings, refer to "2.1 Presetting the Details of Automatic Inspection" in this manual. In this step, configure
the following settings.
[Automatic Reprint when Deviation/Out of Range was Detected]: [OFF]
[Output Tray for Out of Range]: [Same as the Job]
[Create Auto Inspection Report]: [ON]
2
Configure settings in [Auto Inspection Level Detailed Setting].
In this step, change each setting of [Standard] to the desired inspection level value.
3
Create a reference image using the reference chart.
Create a reference image following the procedure described in "3.1 Creating a New Reference Image
for Automatic Inspection" in this manual.
4
Perform automatic inspection using the reference image created in step 3 and the inspection chart.
Perform automatic inspection following the procedure described in "3.2 Selecting the Created Refer-
ence Image for Automatic Inspection" in this manual. Select [Use Registered Image] in [Reference Im-
age Setting], and then select the reference image created in step 3. Also, select [Standard] in
[Inspection Level Setting].
Automatic Inspection Operation Manual
2
2-11