Chapter 6 - Getting Started; Mpower Models; Dual Carrier Firmware For Cellular Radio - Multitech Conduit AP Hardware Manual

Chapter 6 – Getting Started
After powering up your device, refer to the following sources for help configuring and using your device.

mPower Models

If your device uses the mPower platform, getting started information is in
available through your model's page at

Dual Carrier Firmware for Cellular Radio

This device uses a cellular radio with dual carrier firmware meaning that it can be used on different carrier
networks (not simultaneously). The device can be used on either the Verizon or AT&T/other networks. The device
is configured for AT&T/others by default. The device is configured for Verizon by default.
To check that your device is configured for the desired network:
AT#FWSWITCH?
If response is:
#FWSWITCH: 0
The device is configured for AT&T/other networks.
If response is:
#FWSWITCH: 1
The device is configured for Verizon.
To switch carrier networks:
From AT&T to Verizon:
AT#FWSWITCH=1,1
From Verizon to AT&T:
AT#FWSWITCH=0,1
Note: For the Link status (LS) LED to function, you must issue the command AT#GPIO=1,0,2 any time you use
the firmware switch command (AT#FWSWITCH=0 or AT#FWSWITCH=1).
®
Conduit AP MTCAP2-LNA3-915 and MTCAP2-915 Hardware Guide
https://www.multitech.com/brands/multiconnect-conduit-ap
mPower Software Guide
GETTING STARTED
(S000727),
23