Reset System Data - Dawn CONTROL-1500A Manual

CONTROL-1500A Single Axis Antenna Controller
and CONFIG mode items which can change the contents of the controller's non-volatile
memory.
When the Expert Access screen is displayed, the present state of the Expert Access flag is
displayed in the data entry field. A display value of 1 indicates that the Expert Access Flag is
set, and a value of 0 indicates that the flag is reset. To toggle the state of the flag, the user
must key in a 5 digit code at the prompt followed by the ENTER key. This code is found in a
removable Appendix A at the end of this manual. If the information is lost, call the factory for
assistance.
POS
EXPERT ON:
0-no, 1-yes
4.9.8

Reset System Data

The Reset Sys CONFIG mode data item is used to reset the controller's non-volatile memory.
When this occurs, the controller limits are invalidated, and most of the various CONFIG mode
items are initialized to a default value. This operation is usually performed at the factory.
Access to this item is allowed only when the Expert Access flag is set. To reset the system
memory, the user must key in the same 5 digit code used for Expert Access, followed by the
ENTER key.
POS
RESET SYS:
ENTER CODE
Following are the default values which are assigned to non-volatile memory, with a space to fill
in the values for this installation:
Data Item or Condition
Position Count
CCW Limit
CW Limit
Limit Checksum
AutoPol Enable
AutoPol Vlevel
Remote Enable
Comm Address
DAWNco • 3340 S. Lapeer Rd • Orion, MI 48359-1320 • Ph (248) 391-9200 • Fax (248) 391-9207 • sales@DAWNco.com
POL SS
1
CFG
MODE
POL SS
0
CFG
MODE
Chapter 4 Modes Function Description
Default Value
5000
4999
5001
Invalid – The 'Ant Limits' alarm
message flashes on the bottom
row of the LCD
0 - disabled
1 – vertical pol corresponds to a
high level input
0 - disabled
50
51
User
Assigned
Value
_______
_______
_______
_______
_______
_______
_______