Reset Mode - Dawn CONTROL-1500A Manual

CONTROL-1500A Single Axis Antenna Controller
POS
USER
When the Enter key is hit, the controller will display the following screen ...
POS
KEY IN SAT NAME
*
Note that the cursor is displayed under the '*' character. The Scroll Up and Scroll Down keys
allow the user to select alphanumeric characters (A-Z, 0-9, hyphen (-), and space). During
alphanumeric data entry, the Enter key has two functions. If the Enter key is depressed while
the '*' character IS displayed, the alphanumeric data entry session is terminated. If the Enter
key is depressed when the '*' character IS NOT displayed, the cursor will advance to the right
and the user is be prompted with '*' to enter the next character in the string. Note that the
BKSP key will delete characters which have been entered and shift the cursor to the left.
4.6

RESET Mode

Reset mode displays antenna and polarization fault conditions. These fault conditions can
also be reset from this mode (the fault conditions reported in this mode disable movement
about the affected axis.
When Reset mode is activated, one of the following screens will be displayed (if no fault
conditions exist).
POS
ANT-1:
POS
ANT-1,PL-2:
The first screen will be displayed if the controller is configured for a Polarotor (24 VDC Rot
Feed Config item set to zero). The second screen will be displayed if the controller is
configured for a rotating feed (24 VDC Rot Feed item set to one).
The fault status of each axis is displayed on the top line of the LCD below the appropriate
banner (POS or POL). Use the 1 key to reset the antenna axis and the 2 key to reset the
polarization axis.
Here are the status messages that may be displayed:
OK
Indicates that no fault conditions are active for the axis (antenna or polarization).
DAWNco • 3340 S. Lapeer Rd • Orion, MI 48359-1320 • Ph (248) 391-9200 • Fax (248) 391-9207 • sales@DAWNco.com
POL SS
913 220 210
SET
MODE
POL SS
SET
MODE
POL SS
OK
RST
MODE
POL SS
OK OK
RST
MODE
Chapter 4 Modes Function Description
43