Information On Cfw-11 Inverters Relating To The Control Card; Firmware Version Between V3.00 And V4.99 From Serial Number 1011361739; Firmware Version V5.00 Or Higher With Control Card Revision "D" And "D1; Modifications On Slot 5 (Flash Memory Module) - WEG CFW-11 User Manual

Addendum to the CFW-11 User's Manual
2 INFORMATION ON CFW-11 INVERTERS RELATING TO THE
CONTROL CARD
2.1 FIRMWARE VERSION BETWEEN V3.00 AND V4.99 FROM SERIAL
NUMBER 1011361739
ATTENTION!
Firmware version V3.00 or higher CANNOT be used on inverters with
„
serial number under 1011361739, that use a control board with revision
prior to "C".
Any firmware version prior to V3.00 CANNOT be used on inverters with
„
control board revision "C" or higher.
2.2 FIRMWARE VERSION V5.00 OR HIGHER WITH CONTROL CARD REVISION
"D" AND "D1"
ATTENTION!
Firmware version V5.00 or higher CANNOT be used on inverters with
„
control board revision prior to "D".
Any firmware version prior to V5.00 CANNOT be used on inverters with
„
control board revision "D" or higher.
Further information on the new features and corrections of firmware versions V3.00
and V5.00 are provided in a specific addendum to the programming manual (available
only on the CD).

2.3 MODIFICATIONS ON SLOT 5 (FLASH MEMORY MODULE)

To avoid connection failures and to improve the ease of connection to the inverter,
the FLASH memory module (MMF) was modified from MMF-01 to MMF-03. The
following picture shows the differences between MMF-01 and MMF-03 modules
and the ones implemented on the inverter.
The MMF-03 module is incompatible with the older MMF-01 and can only be used on
inverters with serial number starting at 1011361739 that have revision "C" or higher
of the control board.
6 | CFW-11
- English -