Service And Maintenance; Storage Regulations; Transportation; Scope Of Delivery - Paton StandardMIG-160 User Manual

For trouble-free operation! The output phase-to-phase voltage of the generator must be
within the permissible limits:
160-260V (for StandardMIG-160/200/250);
-
320-440V for all three phases (for StandardMIG-270/350).
-

9. SERVICE AND MAINTENANCE

Warning! Before opening the machine, switch it off and disconnect the mains plug.
Allow the internal circuits of the machine to discharge (approx. 5 min.) before proceeding.
Place a sign prohibiting switching on when leaving.
To keep the machine in good working condition for many years, several rules must be
observed:
- Perform safety inspections at specified intervals (see Section "Safety Instructions");
- In the case of intensive use, we recommend blowing out the machine with dry
compressed air once every six months. Warning! Blowing from a too-short distance can
damage the electronic components;
- If there is a large accumulation of dust, clean the cooling ducts manually.

10. STORAGE REGULATIONS

Preserved and packed source should be kept in storage conditions 4 of State Standard
15150-69 for 5 years.
Unpacked source should be stored in a dry closed room at air temperature not lower
than +5 °C. There should be no vapors of acids and other active substances on the
premises.

11. TRANSPORTATION

Packed source can be transported by all means ensuring its safety in compliance with
the rules of transportation established for the relevant type of transport.

12. SCOPE OF DELIVERY

8. Welding arc power source with mains cable
9. Cable with ABICOR BINZEL electrode holder 3m
10. ABICOR BINZEL semi-automatic torch
11. ABICOR BINZEL welding cable with ground terminal 3m
12. Pneumatic quick-release connector
13. Operation manual
14. PATON branded corrugated box
For StandardMIG-160/200/250 models:
- Rollers for solid wire (0.6-0.8; 1.0-1.2)
For StandardMIG-270-400V models:
- Rollers for solid wire (0.6-0.8; 1.0-1.2)
- Transport wheel set
For StandardMIG-350-400V models:
- Rollers for solid wire (0.8-1.0; 1.2-1.6)
- 95 -
PATON StandardMIG DC MMA/TIG/MIG/MAG
– 1 pc;
– 1 pc;
– 1 pc;
– 1 pc;
– 1 pc;
– 1 pc.
– 1 pc;
– 2 set;
– 2 set;
– 1 pc;
– 2 set;