Generator Operation Mode - Paton StandardMIG-160 User Manual

a) 0[OFF] ... 80% (unit increment 5%)
8) Voltage pulsation frequency = 20 Hz (default)
a) 5 ... 500 Hz (unit increment 1 Hz)
9) The pulse/pause ratio (duty ratio) is the percentage of the larger current pulse to the
period of these pulses = 50% (default)
a) 20 ... 80% (unit increment 5%)
On the right wire feeder display:
0) Main displayable parameter Rate feed = 7.0 m/min (default)
a) 2.0 ... 16.0 m/min (unit increment 0.1 m/min)
1) Torch button mode = [2T] (default)
a) [2T] – button mode on the 2T torch
b) [4T] – standard button mode on 4T torch
c) [alt.4T] – alternative button mode on 4T torch
2) Wire feed motor on/off = ON (default)
a) ON – enabled
b) OFF – disabled
3) Pre-purge time with safety gas = 0.1 sec (default)
a) 0.1 ... 25.0 sec (unit increment 0.1 sec)
4) Post-purge time with safety gas = 0.1 sec (default)
a) 0.1 ... 25.0 sec (unit increment 0.1 sec)
5) Wire feeder ramp up speed = 0.1 sec (default)
a) 0 [OFF] ... 5.0 sec (unit increment 0.1 sec)
6) Wire feeder decay speed = OFF (default)
a) 0 [OFF] ... 5.0 sec (unit increment 0.1 sec)

8. GENERATOR OPERATION MODE

The power supply is suitable for operation on a generator under the following conditions:
When working
with an
electrode
Ø2
Ø3
Ø4
Ø5 fusible
Ø5
Ø6 fusible
Ø6
PATON StandardMIG DC MMA/TIG/MIG/MAG
Set current value
for MMA and TIG
Max. 80А
Max. 120А
Max. 160А
Max. 200А
Max. 250А
Max. 270А
Up to 350А
When working with a wire
diameter at MIG/MAG
Max. Ø0.6 mm
Max. Ø0.8 mm
Max. Ø1.0 mm
Max. Ø1.2 mm
Max. Ø1.4 mm
- 94 -
Generator
minimum power
3.0 kVA
4.5 kVA
6.0 kVA
7.7 kVA
10.0 kVA
12.0 kVA
16.0 kVA