Accessing Nokia Network Voyager - Nokia IP300 Series Installation Manual

3
Performing the Initial Configuration
on your network is configured to respond to any request). To reset the
incorrect host name and IP address:
a. Establish a console connection to the appliance.
b. Enter the following:
c. Reboot the appliance.
d. Respond to the
3. At each subsequent prompt, type the requested configuration information
and then press Enter.
For more information about how to respond to the prompts during the
initial configuration process, see the release notes for the Nokia software
release you are running.
4. After you complete the initial configuration, you can use Network
Voyager to configure the remaining network ports.

Accessing Nokia Network Voyager

You can use Network Voyager to configure the remaining network ports on
your IP300 Series appliance.
To open Network Voyager
1. Start Netscape Navigator or Microsoft Internet Explorer on the host you
want to use to complete the configuration.
2. In the Location or Address field, enter the IP address of the initial
interface you configured on the appliance.
You are prompted to enter the admin username and the password you
entered when performing the initial configuration.
30
All manuals and user guides at all-guides.com
rm /config/active
or
mv /config/active /config/active.old
Hostname?
DHCP client from restarting.
Nokia IP300 Series Security Platform Installation Guide
prompt within 30 seconds to prevent the