Table of Contents
Advertisement
3
Performing the Initial Configuration
Connecting Network Interfaces
Connect at least one network interface to the network to use as the Nokia Network Voyager
system-management interface. This interface is configured during the initial configuration
process, which is described in
You can also connect the remaining LAN interface cables at this point, although you are not
required to do so.
Note
Nokia recommends that you use one of the four front-panel Ethernet management ports for
this connection.
To connect Ethernet devices, use a straight-through RJ-45 cable to connect to a 10-Mbps or
100-Mbps hub.
For details, see
To connect Gigabit Ethernet devices, use a fiber-optic cable with an LC connector for each
interface. The destination end of the cable can be either LC or SC, depending on the type of
connector required for the destination Gigabit Ethernet device.
For details, see
Using Nokia Network Voyager
Use Nokia Network Voyager to configure and monitor your appliance. For additional
information about how to use Network Voyager, see
Using Nokia Network Voyager"
To open Nokia Network Voyager
1. Open a Web browser on the host you plan to use to configure or monitor your appliance.
2. In the Location or Address field, enter the IP address of the initial interface you configured
for the appliance.
You are prompted to enter the admin username and the password you entered when you
performed the initial configuration.
Note
If the username login screen does not open, you might not have a physical network
connection between the host and your appliance, or you might have a network routing
problem. Confirm the information you entered during the initial configuration and check
that all cables are firmly connected. For more information, see the troubleshooting
section in the installation guide for your appliance.
44
All manuals and user guides at all-guides.com
Chapter 3, "Performing the Initial Configuration."
"Ethernet NIC Connectors and Cables"
"Fiber-Optic Gigabit Ethernet NIC Connectors and Cables"
later in this section.
IP1220 and IP1260 Security Platforms Installation Guide
on page 59.
"Viewing Nokia IPSO Documentation by
on page 65.
Advertisement
Table of Contents
