Installing The Card - Nokia IP300 Series Installation Manual

Installing the Card

1. Use Nokia Network Voyager, the CLI, or the IPSO shell to halt the
appliance. To use the CLI or IPSO shell, simply enter
2. Loosen the two front-panel retaining screws.
3. Slide the chassis assembly forward to expose the motherboard
components, as the following figure shows.
4. Locate the PMC connectors on the rear of the motherboard.
Caution
Make sure you locate the correct connectors for the VPN
acceleration card. Do not use the PMC connectors located at the
front of the motherboard, those connectors are for NICs.
Nokia IP300 Series Security Platform Installation Guide
All manuals and user guides at all-guides.com
Chassis assembly retaining
screws
Installing an Encryption Accelerator Card
halt
.
00252a
69