Completion - Sub-Zero Designer Series Installation Manual

Installation

Completion

DOOR TRIM INSTALLATION
After the panels have been adjusted, install the decorative
side trim to the door/drawers. To install, start at the top
and align the trim with the front and rear flanges on the
bracket, then snap into place by pushing the trim toward
the back of the panel. Once the top is secure, continue the
installation downward until the remaining trim is com-
pletely secure. Refer to the illustrations below.
SIDE TRIM
FRONT
FLANGE
REAR
FLANGE
Door side trim Bracket flanges
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
SIDE TRIM INSTALLATION
Install the decorative trim strip to the handle side of tall
and column models. The side trim snaps over the bracket
attached to the handle side of the unit. Refer to the
illustration below.
Side trim
KICKPLATE INSTALLATION
Position the kickplate and install using the two mounting
screws. Refer to the illustration below. The kickplate must
be removable for service. The floor cannot interfere with
removal.
A maximum 152 mm decorative kickplate can be attached
to the factory-installed kickplate. The two rows of vented
louvers can be covered if the door panel is a minimum
102 mm from finished floor.
To install a decorative kickplate, remove the paper backing
from the magnets and attach the decorative kickplate to
the magnets. The magnets allow the decorative kickplate
to be removed if necessary.
Turn power on by touching "power" on the control panel.
MAGNET SCREW
Kickplate installation
90° DOOR STOP
A 105° door stop is built into the hinges. To limit the door
swing to 90°, open the door slightly less than 90°, then use
a standard screwdriver blade to remove the existing clips
from each hinge. Locate the 90° clips from inside the plas-
tic bag containing the product literature, then insert the
90° clips onto each hinge. Refer to the illustration below.
WARNING
Follow all city and state laws when storing, recycling,
or discarding unused refrigerators and freezers.
CLIP
90° door stop
subzero.com | 9