Opening Dimensions; Electrical Requirements - Sub-Zero Designer Series Installation Manual

Site Preparation

Opening Dimensions

WINE STORAGE
635 mm
OPENING
DEPTH
TOP VIEW
2134 W
mm
OPENING WIDTH
OPENING
HEIGHT
SIDE VIEW FRONT VIEW
NOTE: 89 mm finished returns will be visible and should be finished to match cabinetry.
19 mm 19 mm
TYPICAL TYPICAL
89 mm 89 mm
FINISHED FINISHED FILLER
RETURN RETURN
W W
FRAMELESS FRAMED
CABINETRY CABINETRY
OPENING DIMENSIONS
457 mm Model
610 mm Model
762 mm Model
The depth of each wine storage model is 610 mm. Allow
for panel thickness when planning the finished opening
depth. A minimum 89 mm finished return is required on all
sides of the opening. Framed cabinets will require addi-
tional finished filler material behind the face frame for a
proper installation. Refer to the illustration.
DUAL INSTALLATION
When installing two units side by side in a dual installa-
tion, the opening width is the width of the two units added
together. A dual installation kit is required for this installa-
tion. If a dual installation kit is not specified, a minimum
51 mm filler strip is required between the units.
Dual installation kits are available through an authorized
Sub-Zero dealer.

Electrical Requirements

Installation must comply with all applicable electrical
codes and be properly grounded (earthed).
W
The electrical supply must be located within the shaded
457 mm
area shown in the illustration and chart below. A separate
610 mm
circuit servicing only this appliance is required. A ground
762 mm fault circuit interrupter (GFCI) is not recommended and
may cause interruption of operation.
The electrical outlet must be positioned with the ground-
ing prong to the right of the thinner blades.
ELECTRICAL SUPPLY LOCATION
457 mm Model
610 mm Model
762 mm Model
LEFT SIDE
OF OPENING
114 A
mm
108
mm
FLOOR
6 mm
Electrical supply location
ELECTRICAL REQUIREMENTS
Electrical Supply 220-240 V AC, 50/60 Hz
Service
Receptacle grounding-type (earthed)
A
152 mm
241 mm
318 mm
10 amp
subzero.com | 3