Reclining Position Of The Backrest - Mercedes-Benz KIDFIX Operating Instructions Manual

MBA_BA.book Seite 31 Freitag, 13. Februar 2009 2:06 14
The headrest 3 must be adjusted so that
there is a space two fingers wide between
the headrest 3 and your child's shoulders.
To adjust the height of the headrest to
fit your child:
3
7
1. Reach into the adjustment handle 7 on
the back of the headrest 3 and pull it
up a little.
This unlocks the headrest.
2. You can now move the unlocked head-
rest 3 to the desired height. As soon as
you release the adjustment handle 7,
the headrest 3 will lock into place.
3. Place the child seat on the vehicle
seat.
4. Have your child sit down in the child
seat and check the height.
Caution! Repeat this process until the
headrest 3 is at the optimal height.

Reclining position of the backrest

The backrest 2 of the child seat can be ad-
justed to any inclination of the vehicle
seat.
Tip! The backrest 2 is held vertically by a
small detent. Press the backrest 2 slightly
to the rear to release the detent.
Please note: optimal protection is guaran-
teed only if the vehicle seat is in an upright
position.
The backrest 2 of the child seat can be mo-
ved backwards into a reclining position in-
dependently of the vehicle seat.
KIDFIX child seat
Fastening using the KIDFIX locking
arms:
1. Fasten the KIDFIX into the ISOFIX
fastening points 18, (see page 32).
19
1
2. Grasp the seat cushion though the
access slot in the cover.
3. Pull the adjustment lever 19 upwards
and hold onto it while you pull the seat
cushion 1 forwards.
Caution! The gap between the seat cus-
hion 1 and the backrest of the vehicle seat
must not be more than 8 cm.
31