INSTALLATION
Fix the brackets:
•
Drill at the marked points (1) (2) (3), using a ɸ10 mm drill bit.
•
Insert the Wall Plugs 11 into the holes (1) (2) (3).
•
Fix the hood fixing bracket 20 with 3 screws 10 (5 x 50) supplied with the hood.
•
Fix a Chimney fixing bracket 21 with 2 screws 10 (5 x 50) supplied with the hood.
Hook the hood body:
•
Open the panel.
•
Remove the Metal grease filter using the handles provided.
•
Hook the hood body to the bracket 20.
•
Level the hood body itself.
•
From the inside of the hood body, fix the screws 10 to Wall Plugs 11 at the points (3).
•
Fit the filter into the hood.
•
Close the panel.
Right
CONNECTIONS
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the
hood to the chimney using either a flexible or
rigid pipe ɸ 150 or ɸ 120 mm, the choice of which
is left to the installer.
•
To install a ɸ 120 mm air exhaust
connection, insert the reducer flange 3
on the hood body outlet.
•
Fix the pipe 4 in position using sufficient
pipe clamps (not supplied).
•
Remove possible charcoal filters.
Wrong
6
DE
EN