During Use; After Use - Dräger FPS 7000 Instructions For Use Manual

Use
3.3

During use

CAUTION
!
Report to operation only with an airtight facepiece!
If the facepiece is not airtight, this could result in physical in-
jury.
Low temperatures
Use "kp comfort" anti-fog agent to prevent fogging of the visor.
High temperatures/variation in thermal stress
CAUTION
!
In case of any damage, e.g. bubbles in the visor, immediately
leave the danger zone. Failures of the facepiece increase the
risk of injury.
The coating may dissolve in some places on visors marked with
APECas. The facepiece is fully serviceable until the end of the
operation. Replace visor after use.
Chemicals
Some substances may be absorbed by the material of the facepiece
and may possibly diffuse into it. For further information please contact
your local Dräger representative.
Potentially explosive areas
Use a water screen or treat the facepiece meticulously with antistatic
spray.
8
3.4

After use

Doff the facepiece:

WARNING
!
Do not doff the facepiece unless you are in a safe environ-
ment.
a. Press the button on the connection piece and simultaneously
pull the lung demand valve out of the connection piece.
b. Push the sliding buckles of the bottom hairnet straps forward
with your thumb and loosen the straps (Figure E).
c. Pull the facepiece away from the face over the head.
CAUTION
!
Do not pull the facepiece at the connection piece to prevent
damaging the facepiece!
Dräger FPS 7000