Adjusting The Cutting Angle - Thermo Scientific CryoStar NX70 Operator's Manual


Move the lateral adjustment lever forward to secure the upper part of the blade holder in the new position.

Adjusting the Cutting Angle

The cutting angle can be adjusted. the recommended cutting angle is approximately 10° for Thermo Scientific
low profile blades.
Note
The factory preset cutting angle is 10°, this value is the recommended cutting angle for Thermo blades. The minimum angle
is 8°, the maximum angle is 12°.

Loosen the clearance angle adjustment screw on the lower left site of the blade holder.
3 - Instrument Setup
23