Thermo Scientific CryoStar NX70 Operator's Manual page 37


Use the fine adjusting knobs to orient the specimen on the x- and y-axes.
Note
The fine adjustment knobs will click into place when the center position has been reached.

Tighten the specimen head clamping lever again.
For further specimen orientation, the specimen chuck can also be rotated by 360° as described below:

Loosen the specimen head clamping lever slightly.

Rotate the chuck as required.

Move the specimen head clamping lever back to its original position.

After the specimen is adjusted, set the cutting window limits - see Setting the Cutting Window.

Use the motorized coarse feed to position the blade close to the specimen.
3 - Instrument Setup
27