Assembly And Operation; Maintenance - Worx WG255.1 Manual

OPERATING INSTRUCTIONS
WARNING! DO NOT USE THE
PRODUCT WITHOUT ATTACHING
THE GUARD AND FRONT HANDLE.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Assembling the Front Handle
Note: Handle screws should
be facing the protective shield.
If the handle is assembled
incorrectly, the tool will not
power on.
Installing and Removing the
battery pack
Checking the battery condition
(only for WG280)
Your battery pack is
UNCHARGED, you must
charge before use.
Charging the battery pack
More details can be found in
WA3732/WA3740/WA3742/
WA3747's manual
OPERATION
Top cutting
WARNING: If any parts
are missing, damaged or
broken, do not operate your
hedge trimmer until all
damaged parts have been
replaced or repaired. Failure to
do so could result in serious
personal injury. DO NOT USE
WITHOUT HANDLE AND
GUARD.
Side cutting
Lubricating the cutting blade
Cordless Hedge Trimmer
HOW TO USE YOUR HEDGE TRIMMER
Allow the cutting blades to reach full speed
before cutting. When operating, keep the
cutting blades away from people and objects
such as walls, large stones, trees, vehicles, etc.
If the blade stalls, immediately stop the
trimmer. Release the two Switch Levers (5 & 6)
before attempting to clear jammed debris from
the cutting blades.
FIGURE
Do not attempt to cut stems that are too thick
for the cutting blade.
TOP CUTTING
Use a wide sweeping motion (See Fig. E1). A
slight downward tilt of the cutting blades in
See Fig. A1,
the direction of motion gives the best cutting
A2
results.
SIDE CUTTING
When trimming the sides of the hedge, begin
at the bottom and cut upwards (See Fig. E2),
See Fig. B1,
tapering the hedge inward at the top. This
B2
shape will expose more of the hedge, resulting
in a more uniformed growth.
See Fig. C

MAINTENANCE

Remove battery from the socket before
carrying out any adjustment, servicing or
See Fig. D
maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
See Fig. E1
See Fig. E2,
E3
See Fig. F
11
EN