Worx WG284E Manual page 11

Rotating rear handle
NOTE :
•
Unlock the locking switch before
rotating.
•
After rotating the handle to the
desired position, adjust it a little
until a click can be heard.
WARNING:
• Always make sure that the
handle is locked in the desired
position before operation.
• Always make sure the locking
switch is locked before starting
the hedge trimmer.
• Do not rotate the handle when
the trimmer is being operated.
Top cutting
WARNING: If any parts are
missing, damaged or broken, do
not operate your hedge trimmer until
all damaged parts have been replaced
or repaired. Failure to do so could result
in serious personal injury. DO NOT
USE WITHOUT FRONT HANDLE AND
SAFETY GUARD.
Side cutting
WARNING: Stop operating the trim-
mer before rotating the handle.
Lubricating the Cutting Blade
NOTE : It is important to use only the
recommended standard lubricating oil
(WD-40) to avoid damage to the blade.
To store your hedge trimmer
Cordless Hedge Trimmer
HOW TO USE YOUR HEDGE
TRIMMER
Before cutting an area, inspect it first and remove
any foreign objects that could become thrown or
entangled in the blades. Always hold the trimmer
with both hands and with the blade away from you
before turning it on.
See Fig.
When trimming new growth, use a wide sweeping
I1, I2
action so that the stems are fed directly into the
blade.
Allow the cutting blades to reach full speed before
cutting. When operating, keep the cutting blades
away from people and objects such as walls, large
stones, trees, vehicles, etc.
If the blade stalls, immediately stop the trimmer.
Release the two Switch Levers before attempting to
clear jammed debris from the cutting blades.
Wear gloves when trimming thorny or prickly growth.
Do not attempt to cut stems that are too thick for the
cutting blade.
Top cutting
Use a wide sweeping motion. A slight downward tilt
See Fig. J
of the cutting blades in the direction of motion gives
the best cutting results.
Side cutting
When trimming the sides of the hedge, begin at
the bottom and cut upwards, tapering the hedge
inward at the top. This shape will expose more of
the hedge, resulting in a more uniformed growth.
See Fig.
K1, K2
BATTERY STATUS (See Fig. F )
•
Before starting or after use, press the button
beside the power indicator light on the machine
See Fig. L
to check the battery capacity.
•
During operation, the battery capacity will be
indicated automatically by the battery power
indicator. The indicator constantly senses and
See Fig. M
displays the battery condition as follows.
•
For the machine with 2 battery packs with
different power, the power indicator light
displays the battery condition with the lower one
of the two batteries.
Battery indicator
light status
Five green lights
(
illuminated.
Two, three or four
green lights are
illuminated.
Only one green
light (
illuminated.
Battery condition
The two batteries are in a
) are
highly charged condition.
The two batteries have a
remaining charge. The more
lights are illuminated, the
more battery capacity.
At least one battery is
) is almost depleted and needs
to be charged.
11
EN