EN
CONTENTS
1.3.1. Timer ......................................................... 4
1.6. Warnings ............................................................ 8
4. SPARE PARTS ........................................................... 21
1. INSTRUCTIONS FOR USE
This heater shall not be operated unless the rock
compartment in the top of the heater is filled with
the rocks, and the guard is in place.
1.1. Piling of the Sauna rocks
The sauna rocks for an electric heater should be 1
9/16" - 3 1/8" (4-8 cm) in diameter. The heater
rocks should be solid blocks of rock specially intend-
ed for use in the heater. Neither light, porous ceramic
"rocks" of the same size nor soft potstones should
be used in the heater, because they may cause the
resistance temperature to rise
too high as a result of which the
resistance may be broken.
Rock dust should be washed
off before piling the rocks. The
rocks should be piled into the
rock compartment over the grat-
ing, between the heating ele-
ments (resistances) so that the
rocks support each other. The
weight of the rocks should not lie
on the heating elements.
FR
TABLE DES MATIÉRES
2. LE SAUNA ................................................................ 10
thermostatique ........................................................ 14
3.8. Dépannage ....................................................... 17
l'entretien ! ............................................................. 18
3.11. Garantie ......................................................... 19
Ce poêle ne doit être mis en fonctionnement qu'une
fois le compartiment à pierres rempli et la monture
de sécurité installée.
1.1. Mise en place des pierres du poêle.
Les pierres convenant au poêle électrique sont des
pierres de diamètre compris entre 9/16" et 3 1/8"
(4 et 8 cm). Dans les poêles à sauna il faut utiliser
uniquement des pierres prévues à cet effet, taillées
dans la masse. Ne pas utiliser de pierres en céra-
mique de calibre identique, légères et poreuses. Elles
Figure 1.
Piling of the sauna rocks
Figure 1.
Mise en place des pierres du poêle.
1.3.2. Thermostat ................................................ 5
1. MODE D'EMPLOI
risquent de provoquer une sur-
chauffe et la cassure des éléments
chauffants. Il en est de même des
pierres ollaires.
Laver les pierres avant leur ins-
tallation. Placer les pierres dans
le compartiment à pierres, sur la
grille, entre les éléments chauf-
fants (résistances), empilées en
appui les unes sur les autres. Le
poids des pierres ne doit pas repo-
ser sur les éléments chauffants.
3