Deli SanDwich ToaSTer (DST-200) table Of cOntents adjusting toasting Quality .........7 Owner Information .............2 Programming the Dst-200 ........8 general ..............2 Dst-200 Default settings ..........8 Warranty information ..........2 Dst-200 unit status Mode ........9 service/technical assistance ........2 Purging Products from the toaster ......9 specifications .............3 shutting Down the Dst-200 ........10 electrical Ratings &...
Deli SanDwich ToaSTer (DST-200) ImpOrtant safety InfOrmatIOn throughout this manual, you will find the following safety words and symbols that signify important safety issues with regards to operating or maintaining the equipment. WarnInG WarnInG General WarnInG. Indicates information electrIcal WarnInG. Indicates information important to the proper operation of the equip- relating to possible shock hazard.
If any parts are missing or damaged, The unit displays contact technical service ImmeDIately LOWER I/R this message for Antunes DST-200 at 1-877-392-7854 (north america only), or #####, #####, ##### approximately 2 UPPER I/R seconds.
Deli SanDwich ToaSTer (DST-200) OperatIOn (continued) changing modes toasting product follow these steps to change between Deli 1 mode and the Dst-200 can toast a variety of bread products. Deli 2 mode. However, when toasting ciabatta breads, french breads, or other long thin breads, refer to items 1 and 2 below. nOte: Do nOt toast any products until the unit dis- plays “Deli 1 Ready”...
Deli SanDwich ToaSTer (DST-200) OperatIOn (continued) 2. use the preV and neXt buttons to adjust the CORRECT toasting quality to lighter or darker respectively (figure 2). nOte: pressing the preV button decreases toast- ing darkness. pressing the neXt button increases toasting darkness.
Deli SanDwich ToaSTer (DST-200) OperatIOn (continued) programming the Dst-200 Dst-200 Default settings the table below shows the default settings for the nOte: reprogramming the Dst-200 is nOt Dst-200 toaster. Note that Deli 1 and Deli 2 are recommended. the factory default settings should shipped with the same pre-programmed values.
Deli SanDwich ToaSTer (DST-200) OperatIOn (continued) Dst-200 Unit status mode 2. facInG tHe frOnt Of UnIt With the unit in Deli 1 or Deli 2 mode, press this mode provides feedback on how the unit’s sys- and hold the pUrGe button to purge product from tems are performing.
Deli SanDwich ToaSTer (DST-200) OperatIOn (continued) shutting Down the Dst-200 WarnInG to avoid possible personal injury and/or dam- follow these steps to shut down the toaster: age to the unit, all inspections, tests, and repair 1. turn the Power switch off (figure 2). the LeD on of electrical equipment should be performed by the switch turns off.
Deli SanDwich ToaSTer (DST-200) maIntenance 8. Press the pUrGe button to stop the conveyors. WarnInG the unit will remain hot to the touch while it is 9. use a damp cloth and general purpose cleaner to cooling down. personal injury and burns may clean the exposed section of the top and bottom result from touching the unit before it is finished conveyor.
Deli SanDwich ToaSTer (DST-200) trOUblesHOOtInG caUtIOn to avoid possible personal injury and/or damage to the unit, all inspections, tests, and repair of electrical equipment should be performed by QUalIfIeD serVIce persOnnel. the unit mUst be shut down and UnplUGGeD before servicing, except when electrical tests are required. Use extreme care during electrical circuit tests.
Page 13
Deli SanDwich ToaSTer (DST-200) trOUblesHOOtInG problem possible cause corrective action cooling fan speed error. unit displays cooling fan failure. the toaster will operate normally one or more of the following until the compartment ambient tem- messages: perature exceeds 150ºf (66 .
Warranty equipment manufactured by Roundup food equipment Division of a.J. antunes & co. has been constructed of the finest materials available and manufactured to high quality standards. these units are warranted to be free from mechanical and electrical defects for a period of one year from date of purchase or 18 months from shipment from factory, whichever occurs first, under normal use and service, and when installed in accordance with manufacturer’s recommendations.
Need help?
Do you have a question about the Roundup DST-200 and is the answer not in the manual?
Questions and answers