Table of Contents
Advertisement
If the IP Access Mode field is set to DHCP and the LGW function is ON
Type field must be modified. The IP address of the eNB will be changed due to the MAC address
being changed. Therefore, modify the router server at the same time.
The LAN Config interface is used only as a local maintenance port during initial eNB setup and basic
configuration; it is not used during normal eNB operation. Enter the IP address and subnet mask
address for the local network connection. The default IP address for the LAN interface is
192.168.150.1.
NOTE: If the LAN IP address is changed, the eNB will reboot, and you will have to log in to
the GUI again.
Figure 3-14: WAN/LAN/VLAN
Table 3-1: WAN/LAN/VLAN
Field Name
Description
Allow Management
Enable or disable the Local Maintenance Terminal connection through the
Access Over WAN
WAN port.
Connect Type
Used to select the type of connection for the eNB (Copper or Fiber)
(section
25
3.5.3.2), the Connect
Advertisement
Table of Contents
