Table of Contents
Advertisement
for detailed instructions regarding firmware upgrades.
3. Set the Network Timing Protocol (NTP).
For help, refer to the
CloudCore Configuration & Network Administration
3.7.2 Upgrade Firmware
To ensure you are using the most recent software version before configuring the eNB, follow the
steps below.
3.7.2.1 Upgrade Firmware from the eNB GUI
1. Download the most recent firmware file from Baicells.com > Support > Firmware, and save
on local computer.
2. Go to System > Upgrade, and select whether to preserve the current settings.
3. Select Choose File, and navigate to the firmware file saved on local computer.
NOTE: The file type is *.IMG
4. Click Upgrade.
5. In the pop-up window click PROCEED.
6. The base station reboots after approximately three minutes.
7. On the Basic Setting > Basic Info page, the upgraded version is displayed in Software
Version.
3.7.2.2 Upgrade Firmware from the OMC
1. Go to eNB > Upgrade > Upgrade&Rollback.
2. Select the correct Product Type from the list.
3. Select the checkbox next to the eNB(s) you want to upgrade.
4. In the New Task window, select the Upgrade Type.
5. In the eNB section, select the checkbox(es) next to the eNB(s) you want to upgrade.
6. Next to File List, select/deselect Retain Configuration. Under Select, choose the software
version by clicking in the empty cell (a blue checkmark will appear).
7. Choose the Execute Type, which determines when the upgrade will occur.
8. Select OK.
23
Guide.
Advertisement
Table of Contents
