Table of Contents
Advertisement
3.3.2 Connect Ethernet Cable
Refer to Figure 3-8 to complete the Ethernet cable connection.
1. Connect the Ethernet cable to the ETH interface in the wiring cavity.
2. Lay the Ethernet cable along the wire groove, and stretch out the wiring cavity from ETH hole.
3. The Ethernet cable connects to the PoE interface of the PoE adapter.
4. The LAN interface of the PoE adaptor connects to a LAN switch or a router for maintenance
and backhaul.
NOTE: The PoE adaptor must be placed in the distribution box for waterproofing.
3.4 eNB Grounding
3.4.1 Connect Grounding Cables
Prepare the grounding cable according to the actual measurements and requirements of the
specific installation site. The Nova430i eNB has two grounding screws located on the bottom of the
unit, as shown in Figure 3-8. Follow the steps below the figure to connect the ground cable.
NOTE: All Nova eNBs have a floating ground on the power system.
1. Unscrew one grounding screw, connect one end of the ground cable to the grounding
screw, and retighten the screw.
2. Repeat
step 1
for the second grounding screw.
3. Once the eNB is installed at the outdoor location, the other end of the ground cable needs
to connect to a good earth grounding point.
Figure 3-8: Connect Cables and Grounding Screws
Before installing the eNB at its final destination, perform the steps in
successful testing, the eNB will be ready for installation at the cell site. Seal and weatherproof all
the connection points, and rustproof where needed.
sections 3.6
18
and 3.7. Upon
Advertisement
Table of Contents
