Table of Contents
Advertisement
5. Using the two pins on the bracket on the back of the eNB, attach the eNB to the mounting
bracket on the wall. Push the eNB until the hook is firmly attached to the mounting bracket.
Tighten the bolt on the top of the bracket using a Phillips-head screwdriver to complete
the installation (Figure 3-7).
Figure 3-7: Completed Installation
3.3 Connect Cables
WARNING:
Ensure the antenna is connected before powering up the eNB. The wireless
signal transmission power can cause bodily injury and damage to the eNB and Radio
Frequency (RF) power amplifier devices.
3.3.1 Cable Laying Requirements
General requirements:
Bending radius of antenna feeder cable: 7/8 in > 9.84 in (250 mm),
4/5 in > 14.96 in (380 mm)
Bending radius of jumper cable: 1/4 in > 1.38 in (35 mm)，
1/2 in (super soft) > 1.97 in (50 mm), 1/2 in (ordinary) > 5 in (127 mm)
Bending radius of power cable and grounding cable: > triple the diameter of the cable
Bind the cables according to the type of cable; intertwining and crossing are forbidden.
An identification label should be attached after the cable has been laid.
Grounding cable laying requirements:
The grounding cable must connect to the grounding point.
The grounding cable must be separated from the signal cables, of enough distance to avoid
signal interference.
17
Advertisement
Table of Contents
