3.2.2 Install on Wall
Ensure that the wall can bear at least four times the weight of the eNB. Follow the steps below to
install the Nova430i eNB on a wall.
1. Take apart the assembled installation bracket.
2. Place the installation bracket on the wall with the arrow facing upward, as shown in
Figure 3-5. Mark the drilling locations using a pencil or marker.
3. Drill two holes in the wall to match the size of the wall bracket holes (Figure 3-5).
Figure 3-5: Mark and Drill Holes
4. Check the up/down direction of the installation bracket, and then attach to the wall using
expansion bolts (Figure 3-6).
Figure 3-6: Attach With Expansion Bolts
16