Ferm ESM1014 Original Instructions Manual page 7

Only use the following batteries of the FX-POWER
20V battery platform. Using any other batteries
could cause serious injury or damage the tool.
CDA1167 20V, 2Ah Lithium-Ion
CDA1168 20V, 4Ah Lithium-Ion
The following charger of the can be used to
charge these batteries.
CDA1169 Charger adapter
CDA1170 Quick charger
CDA1172 Quick charger
The batteries of the FX-POWER 20V battery
platform are interchangeable with all the FERM
FX-POWER battery platform tools.
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 62841; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned:
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
page 2 and 3.
1. On/off switch
2. Dust bag
3. Speed adjustment wheel
4. Sanding pad
5A. Upper grip
5B. Lower grip
6. Dust extraction port
7. Battery unlock button
8. Battery (not included)
9. Sanding paper
10. Rubber ring
3. ASSEMBLY
Before any work on the power tool,
remove the battery.
The battery must be charged before first
use.
Inserting the battery into the machine (Fig. C)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (8) into the base of the
machine as shown in Fig. C.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. C)
1. Push the battery unlock button (7).
2. Pull the battery out of the machine like shown
in Fig. C.
Connecting the dust bag (Fig. D)
It is highly recommended to use the machine with
the dust bag (2), ensuring optimal dust collection.
• Slide the dust bag (2) onto the dust extraction
port (6) using a slight twisting motion.
• Keep sliding in twisting motion until the dust
bag (2) is positioned slightly over the rubber
ring (10), fixing it in place.
Note: The dust bag should be emptied when the
bag is half full to maintain optimal dust collection.
Mounting and removing the sanding paper
(Fig. B)
• Hold the machine on its side or upside down.
• Mount sanding paper (9) with the required grain
size onto the sanding pad (4). Make sure that the
perforation in the sanding paper (9) corresponds
with the perforation on the sanding pad (4).
• To remove the sanding paper (9), simply pull
the sanding paper from the sanding pad (4).
Note: Use coarse sanding paper for sanding
rough, uneven surfaces. Use medium sanding
paper for removing the remaining scratches from
the coarse sanding paper. Use fine sanding paper
for finishing surfaces.
7