Baur PD-TaD 62 User Manual page 45

PD-TaD 62
No. Cable
1 Protective earthing
cable of the VLF HV
generator
2 Protective earthing
cable of PD-TaD 62
(flat copper strip)
On the VLF HV generator:
– –
3 Connection cable
C13 – C14G
On the laptop:
4 Ethernet cable
– –
At the PD-TaD 62:
5 PoE cable
tan δ cable
6
–
7
8 HV connection cable of
the VLF HV generator
9 Short-circuit cable of
PD-TaD 62
At the far end of the test object:
–
10
822-187-3
Step
Earth the VLF HV generator.
Further information: User manual for the respective VLF HV generator
Connect the PD-TaD 62 to the station earth (close to the test object cable
screen).
Further information: Chapter Earth system (on page 35)
If present, connect the external emergency off unit to the VLF HV generator
( port).
If you are not using an external emergency off unit, ensure that a jumper
plug is inserted into the
Connect the VLF HV generator (mains supply) to the Power Box (port
depends on the connection cable).
Use the supplied Ethernet cable to connect the laptop to the Power Box
(Laptop port).
If you do not want to run the laptop off its battery, connect the laptop to the
Power Box to establish a power supply. To do so, use the connection cable
with the C14G plug.
Connect the PoE cable:

to the Power Box (PD Detector port) and

to PD-TaD 62 (Power Box port)
This is used for power supply and data transmission at the same time.
Connect the tan δ cable:

to the VLF HV generator (PD Detector port) and

to PD-TaD 62 (VLF Generator port).
Connect the HF filter to the HV IN port.
Further information: Chapter Connecting the HF filter to the PD-TaD 62 (on
page 55)
Connect the HV connection cable to the HF filter at the HV IN port.
Further information: Chapter Connecting the HF filter to the PD-TaD 62 (on
page 55)
On the PD-TaD 62, remove the short-circuit cable from ports HV IN and
HV OUT.
Clean the cable termination of the phase to be tested carefully.
Connecting the system
port on the VLF HV generator.
45 / 114