S
A
ETUP AND
SSEMBLY
14
Tube Fitting Instructions
1.
Cut the 1/4" O.D. tubing cleanly, at a slight
angle, to make insertion of end easy.
2.
Loosen the nut on the fitting until about three
threads are visible, moisten the tubing and
insert into the nut opening until it stops. (See
Figure 6).
3.
Tighten the nut by hand; additional tightening
should not be necessary.
Figure 6
Final Assembly Instructions
1.
Remove "Operation" label from parts box. Peel
off paper backing and apply label at any con-
venient location on Deionizer.
2.
If setup is for Deionizer Only, proceed to
Cartridge Installation.
3.
Remove the hole plug from the end panel (See
Figure 7).
4.
Install the rectangular plug from either the
Solenoid Valve or Still Adapter Cord into the rec-
tangular accessory receptacle.
5.
Plug the phone jack end of the Still Adapter
Cord into the control box on the MEGA-PURE®
Water Still.