Table of Contents
Advertisement
Note
This setup assumes that your Barnstead
MEGA-PURE Water Still is now con-
nected to your water source and that
you have Part No. 440376 Still Adapter
Kit (purchased separately).
Deionizer to a Barnstead MEGA-PURE
Still - Figure 5
1.
Refer to Figure 5 and instructions and install
plastic "T" fitting from Still Adapter Kit into the
source water line now feeding your Still as
shown in Figure 5. Locate as desired.
2.
Connect the 1/4" O.D. High Pressure tubing to
this "T" fitting as shown in Figure 5.
3.
Route 1/4" I.D. Vinyl tubing to same drain as
water still.
4.
Route 7/16" I.D. Vinyl tubing to constant level
chamber of still as shown. Go to Final Assembly
Instructions on page 14.
S
A
ETUP AND
SSEMBLY
13
Advertisement
Table of Contents
