Mount Transmission Elements; Connecting The Electric Supply; Safety - Bosch Rexroth MAD100 Operating Instructions Manual

MAD / MAF Asynchronous Housing Motors
6.1.3

Mount transmission elements

6.2

Connecting the electric supply

6.2.1

Safety

Fit and pull off the transmission elements such as pulleys and couplings only
with suitable equipment; heat them, if necessary.
Avoid inadmissible belt tensions. Please consider the allowed radial and
axial forces within the project planning manuals.
The balancing state of transmission element must comply with the balanc‐
ing mode of the motor.
NOTICE
axial and radial forces of the motor.
Fitting
Fig. 6-2: Fitting the transmission element
Use the centering hole for fitting transmission elements. For details about
centering holes refer to the project planning manual
ing Motors MAD/MAF. Heat the transmission element, if necessary.
WARNING
Work required on the electric system may only be carried out
by skilled electricians. Tools for electricians (VDE tools) are
absolutely necessary.
Prior to commencing work:
Motor damage due to strikes onto the motor
shaft
Do not strike the shaft end and do not exceed the allowed
Danger! Electric voltage! Operations in the vi‐
cinity of live parts are extremely dangerous.
1. Isolate (even auxiliary circuits).
2. Secure against reactivation.
3. Ensure de-energization.
4. Ground and short-circuit.
5. Cover or shield any adjacent live parts.
R911336186_Edition 02 Bosch Rexroth AG
21/57
Assembly
Asynchronous Hous‐