How To Attach Options To The Plasma Monitor - NEC PlasmaSync 42PD3 User Manual

How to Attach Options to the Plasma Monitor

You can attach your optional mounts or stand to the plasma moni-
tor in one of the following two ways:
In the upright position.
Lay the screen face down.
Lay the protective sheet, which was wrapped around the monitor
when it was packaged, beneath the screen surface so as not to
scratch the screen face.
This device cannot be used or installed without a separate
Tabletop Stand or other optional mounting accessory. For
proper installation it is strongly recommended to use a
trained, NEC authorized service person. Failure to follow
correct mounting procedures could result in damage to the
equipment or injury to the user or installer. Product war-
ranty does not cover damage caused by improper installa-
tion. Failure to follow these recommendations could re-
sult in voiding your warranty.
* Use only Listed Cart or Stand, or mounting kit or provided by
manufacturer.
8
P M
LASMA ONITOR
†
Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surrounding ob-
jects as shown in the diagram to the right.
50mm (1.97")
31mm (1.22")
50mm (1.97")
31mm (1.22")
45mm
(1.77")