How To Attach Options To The Plasma Monitor - NEC PlasmaSync 61XM1A User Manual

How to Attach Options to the Plasma Monitor

You can attach your optional mounts or stand to the plasma
monitor in the following way:
* Unpack the plasma monitor. (See Drawing A.)
* Take it out, put your hand in the handy-grip recess at the
rear, and move it to an appropriate place. Then attach the
optional mounts or stand. (See Drawing B.)
• This device cannot be installed on its own.
Be sure to use a stand or original mounting
unit. (Wall mount unit, Stand, etc.)
* See page 2.
• For correct installation and mounting it is
strongly recommended to use a trained,
authorized NEC dealer.
Failure to follow correct mounting
procedures could result in damage to the
equipment or injury to the installer.
Product warranty does not cover damage
caused by improper installation.
* Use only Listed Cart or Stand, or mounting
kit or stand provided by manufacturer.
Ventilation Requirements for
enclosure mounting
To allow heat to disperse, leave space between
surrounding objects as shown on the diagram
below when installing.
Drawing A
Drawing B
Wall
50 (2")
mm
1580
1
50 (2")
mm
(62.2")
mm
Wall
50 (2")
mm