Table of Contents
Advertisement
How to Attach Options to the Plasma Monitor
You can attach your optional mounts or stand to the plasma
monitor in one of the following two ways:
* In the upright position. (See Drawing A)
* Lay the screen face down (See Drawing B). Lay the
protective sheet, which was wrapped around the monitor
when it was packaged, beneath the screen surface so as
not to scratch the screen face.
This device cannot be used or installed with-
out a separate Tabletop Stand or other op-
tional mounting accessory. For proper instal-
lation it is strongly recommended to use a
trained, NEC authorized serviceman. Failure
to follow correct mounting procedures could
result in damage to the equipment or injury to
the user or installer. Product warranty does
not cover damage caused by improper instal-
lation. Failure to follow these recommenda-
tions could result in voiding your warranty.
Ventilation Requirements for en-
closure mounting
To allow heat to disperse, leave space between surround-
ing objects as shown in the diagram to the right.
Pulling Out and Reinserting the
Retractable Feet
The Retractable Feet are housed at 2 locations on the bot-
tom surface of the main unit.
1. Grasp the end and pull out.
2. The feet will open automatically when your hand is re-
moved.
To house the Retractable Feet, close them and then
continue to push them inside the main unit.
Notice:
* Installation of only the main unit is not possible. Be sure
to use and install the main unit in conjunction with a
stand or special unit.
Note:
RETRACTABLE FEET ARE FOR TEMPORARY USE
ONLY AND ARE NOT INTENDED FOR PERMA-
NENT INSTALLATION.
MODEL # PX-42VPU1-ST STAND IS REQUIRED
FOR PERMANENT TABLETOP INSTALLATION.
REPLACE THE FEET WHEN YOU MOVE THE
MONITOR.
Drawing A
Drawing B
31
mm
(1.22")
1
E-6
50
(1.97")
mm
31
mm
(1.22")
50
(1.97")
mm
45
(1.77")
mm
2
Wall
Advertisement
Table of Contents
