Packaging; Unpacking; Installation - Labnet I5110A Instruction Manual

5.0 Packaging

Product
Labnet Mini Incubator
Shelf (Cat. No. I5110-SHELF)
Instruction Manual

6.0 Unpacking

Before starting the installation, carefully examine the incubator.
Open the box and carefully remove the padding. Check that the incubator has not been visibly damaged during transportation. Keep

the packing material until you are sure that the incubator works properly.
Carefully lift the device out of the box.

Be sure that the following information is included on the serial label located on the back of the unit: serial number, product number,

electrical rating.
Check that the power cord plug has a pin configuration that matches a wall socket according to the local standard.

Should any kind of damage have occurred during transportation, contact the carrier immediately. The carrier is responsible for
shipping damage.

7.0 Installation

Place the incubator on a horizontal, level, and stable surface. Connect the plug end of the cord to a grounded wall socket. Avoid lines
on which powerful electric motors, refrigerators and similar devices are connected. Use the Power switch to control power to the
incubator.
Use caution when plugging into a grounded wall socket. Do not touch the plug with wet hands.
Do not unplug by pulling on the cord.
2 | LABNET MINI INCUBATOR
Quantity
1
1
1