1.0 Introduction The Labnet Mini Incubator is a compact general purpose convection incubator capable of uniformly heating samples up to a maximum of 70°C. The unit comes with a movable shelf and has a door window area so samples can be observed without opening the door causing heat loss.
5.0 Packaging Product Quantity Labnet Mini Incubator Shelf (Cat. No. I5110-SHELF) Instruction Manual 6.0 Unpacking Before starting the installation, carefully examine the incubator. Open the box and carefully remove the padding. Check that the incubator has not been visibly damaged during transportation. Keep ...
10.0 Troubleshooting Should you have a question about the Labnet Mini Incubator or require service for the unit, contact Corning Customer service at 800.492.1110 or 978.442.2200. Do not send a unit for service without first calling to obtain a repair authorization (RA) number. The unit should be properly packed to avoid damage.
(WEEE), this product is marked with the crossed-out wheeled bin and must not be disposed of with domestic waste. Consequently, the buyer shall follow the instructions for reuse and recycling of waste electronic and electrical equipment (WEEE) provided with the products and available at www.corning.com/weee. LABNET MINI INCUBATOR...
Page 7
To request certificates, please contact us at www.labnetlink.com. Warranty/Disclaimer: Unless otherwise specified, all products are for research use or general laboratory use only.* Not intended for use in diagnostic or therapeutic procedures. Not for use in humans. These products are not intended to mitigate the presence of microorganisms on surfaces or in the environment, where such organisms can be deleterious to humans or the environment.