Commissioning; Initial Commissioning - Bosch rexroth BS 1 Series Assembly Instructions Manual

Hide thumbs Also See for rexroth BS 1 Series:
Table of Contents

Advertisement

22/40

Commissioning

Bosch Rexroth AG, MIT: BS 1/..., 3 842 563 815/2021-11
8 Commissioning

8.1 Initial commissioning

Sudden movements, falling workpiece pallets
Injuries caused by falling objects.
Make sure that the product has been assembled properly by qualified
personnel (see page 8) before starting it up.
Malfunctions due to incorrect assembly and commissioning
The product can get damaged, shortening its service life.
Commissioning requires basic mechanical, pneumatic and electrical
knowledge.
The product should only be commissioned by qualified personnel
(see page 8).
• Before the initial commissioning or re-commissioning of a conveyor system,
carry out a risk assessment in accordance with DIN EN ISO 12100.
• According to EU Machinery Directive 2006/42/EC, you must equip the transfer
system with EMERGENCY STOP control devices.
• The surfaces of motors and gears can reach temperatures of over 65 °C under
certain load and operating conditions. In these cases, you must comply with the
respective applicable accident prevention regulations (UVV) by taking appropriate
constructive measures (safety guards) or by affixing/displaying appropriate
warning signs!
• Make sure that all electrical and pneumatic connections are either used or
covered. Make sure that all bolted connections and plug-in connections are
properly seated. All relevant protective covers must be fitted.
• Only inspect and adjust continuous conveyors that are in motion or operation
when the protective equipment is in place.
• Observe DIN EN ISO 13857 when you remove or replace protective equipment
and/or bypass safety equipment.
• Test runs with open paneling should only be performed by a person with
appropriate knowledge and experience using tip switches, and if there is no
possibility of interference from other switching devices.
• Only commission the product if all safety equipment has been installed in the
system and is ready for use.
CAUTION
NOTICE

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents