Assembly; Unpacking; Installation Requirements; Installation Position - Bosch rexroth BS 1 Series Assembly Instructions Manual

14/40

Assembly

Bosch Rexroth AG, MIT: BS 1/..., 3 842 563 815/2021-11
7 Assembly

7.1 Unpacking

Lift the product out of its packaging.
„
Dispose of the packaging material in accordance with the applicable regulations
„
in your country.

7.2 Installation requirements

During installation, be sure to maintain the ambient conditions specified in the
„
technical data (see page 36).
7.2.1

Installation position

Install the product level and plumb, at right angles, and axially parallel.
„
This ensures proper functioning and prevents premature wear.

7.3 Required tools

• Hex wrench (open-ended spanner) SW8, SW10, SW13, SW19, SW24.
• Hex socket wrenches SW3, SW4, SW5.
• Hexagon socket wrench (Torx™) T30, T50
• Phillips screwdriver PH2
• Spirit level
• Combination pliers
• Flat smooth file

7.4 Required accessories

• Section supports for holding up the belt section.
Please note: Support the belt section in the immediate vicinity of the drive and
return unit. Max. distance between two leg sets: 2000 mm.
– for BS 1, BS 1/T, BS 1/M, BS 1/S
SZ 1, 3 842 996 336 or
SZ 1/L, 3 842 996 335
Mounting kit, 3 842 523 431
• For fastening the leg sets on the ground, you need the following for each
connection:
– 1x foundation bracket, 3 842 146 815
– 1x dowel, 3 842 526 560
– 2x T-bolts, 3 842 528 718
– 2x flange nuts, 3 842 345 081
• Connection kit for transverse conveying, for utilization of the belt section in
lateral transverse conveying (drive head-at-section).
– BS 1/..., 3 842 525 110
• Connection kit for longitudinal conveyor (drive head at return unit)
– BS 1/..., 3 842 525 110