Page 1
A WILSON ELECTRONICS BRAND DRIVE X FLEET PROFESSIONAL VEHICLE CELL SIGNAL BOOSTER KIT Installation Guide Use our weBoost App to guide you through the installation. See inside page for more details. support.weboost.com 1-866-294-1660 NEED HELP?
Page 2
Download the weBoost App Download the weBoost App Use our app to guide you through setting up a weBoost cell phone signal booster in your home, business, or vehicle. Boost every network, including 5G, right away. Videos to guide you...
Page 3
______ Index Package Contents Drill Cable Entry Hole To Your Vehicle STEP 1: Mount NMO Outside Antenna STEP 2: Mount In-Vehicle Antenna STEP 3: Wire The Power Supply STEP 4: Connect Coax Cables To Booster STEP 5: Connect Power Supply To Booster STEP 6: Light Patterns Troubleshooting...
Page 4
________ Package Contents In-Vehicle Outside NMO Power Drive X Antenna Antenna + Supply Booster Connector & Bracket Mounting Cable Optional Antenna Protective Tape O-Ring Lubricant Extension Cable For Installation Packet PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT DRIVE X FLEET...
Page 5
Good NMO Outside 12 in. away from windows Antenna Placement (including sunroofs) DRIVE X FLEET PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT...
Page 6
Place the protective tape on the vehicle surface vehicle in the desired location. protective tape Using a 3/4” hole saw, drill a hole in the center of the protective tape. 3/4” bit protective tape PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT DRIVE X FLEET...
Page 7
For a professional installation, we recommend routing the cable under the headliner and down through the side trim panel to the desired booster location on the floor of the vehicle. side trim panel DRIVE X FLEET PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT...
Page 8
NOTE: DO NOT apply silicone grease to the antenna pin contact surface. apply silicone grease screw on NMO Antenna apply silicone grease hand tighten and make sure gasket is touching vehicle surface PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT DRIVE X FLEET...
Page 9
36 inches from where the cell phone device will be used. Adhesive and Velcro® mounting options are included. seat option dash option In-Vehicle In-Vehicle Antenna Antenna clean surface of dash before attaching adhesive strip DRIVE X FLEET PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT...
Page 10
PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT DRIVE X FLEET...
Page 11
NOTE: Bracket can be used to fasten booster in a specific location if desired. from NMO Outside Antenna Connect the cable from the in-vehicle antenna to the port labeled “Inside Antenna” on the booster. from Inside Antenna DRIVE X FLEET PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT...
Page 12
NOTE: Do NOT connect the power to the signal booster until you have connected both the Inside and outside antennas. Power Supply PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT DRIVE X FLEET...
NOTE: The signal booster can be reset by disconnecting and reconnecting the power supply. After troubleshooting you must initiate a new power cycle by disconnecting and then reconnecting power to the booster. support.weboost.com 1-866-294-1660 NEED HELP? DRIVE X FLEET PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT...
The best way to keep these spheres of signal from overlapping is to maximize separation between the inside and outside antennas. PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT DRIVE X FLEET...
______ Safety Guidelines Use only the power supply provided in this package. Use of a non-weBoost product may damage Low profile antennas must have at least 1.5’ separation distance from all active users. Connecting the Signal Booster directly to the cell phone with use of an adapter will damage the cell phone.
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2)) This device must accept any interference, including interference that may cause undesired operation of the device. Changes or modifications not expressly approved by weBoost could void the authority to operate this equipment. support.weboost.com...
2 YEAR WARRANTY weBoost Signal Boosters are warranted for two (2) years against defects in workmanship and/or materials. Warranty cases may be resolved by returning the product directly to the reseller with a dated proof of purchase. Signal Boosters may also be returned directly to the manufacturer at the consumer’s expense, with a dated proof of purchase and a Returned Material...
Page 19
Notes support.weboost.com 1-866-294-1660 NEED HELP? DRIVE X FLEET PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT...