Table of Contents
Advertisement
5.
WEB INTERFACE
The 7814UDX-4K series of products are controlled using Web Interface. WebEASY
Ethernet and SNMP control protocols. The 7814UDX-4K series modules DO NOT HAVE card edge
controls. As a result, 7700FC/7800FC modules must be installed in all frames that house 7814UDX-4K
series modules. Refer to the Evertz website for the most recent firmware for the 7700FC/7800FC.
For the sake of brevity, the following sections describe module controls in terms of the parameters found
within the Web Interface screens for the 7814UDX-AES8-4K+APROC+VPROC. The vast majority of
controls are the same for the XC, UC and HDC versions of 7814UDX-4K series modules. Exceptions to
this are outlined in section 1.1 of this manual. As additional features and options are released, additional
sections will be appended to this manual to show those control screens.
Login
After the card has been installed and configured with the required network addresses for the control port,
it can be completely configured using the web interface. For doing this, simply type the IP address of the
control port of the 7814UDX-4K Series module in the web browser.
NOTE: The Web interface can only be supported if the 7800FC or 7801FC are being
used.
( WebEASY
Note: Computer must be on the same Subnet in order to have communication with the module.
Login and Password is "customer".
On the web interface there are 15 different types of menus as is shown in Figure 5-2.
doesn't work with 7700FC)
®
Figure 5-1 : WebEASY
Revision 1.2
HD/3G/UHD Up/Down/Cross Converters
- Login Menu
®
7814UDX-4K Series
operates using
®
Page - 17
Advertisement
Table of Contents
