Page 1
San Diego - Slimline Console Table Assembly Instructions - 343/7058 Please keep for future reference Dimensions Width - 67cm Depth - 29cm MADE IN Height - 80cm BRITAIN Important - Please read these instructions fully before starting assembly If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800 Issue 1 - 04/11/14...
Safety and Care Advice Important - Please read these instructions fully before starting assembly • Warning: This unit weighs • Make sure you have enough • We do not approximately 13kgs. space to layout the parts before recommend the Please lift with care. starting.
Page 3
If you have damaged or missing components, call the Components - Panels Customer Helpline: 08456 400800 quoting the reference numbers below Please check you have all the panels listed below (DF2100) (597 x 265mm) Base (D2620A) Left Side Right Side (597 x 280mm) (DF2101) (DF2102)
Page 4
If you have damaged or missing components, call the Components - Fittings Customer Helpline: 08456 400800 quoting the reference numbers below Please check you have all the fittings listed below Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required.
Page 5
If you have damaged or missing components, call the Assembly Instructions Customer Helpline: 08456 400800 quoting the reference numbers below Step 1 Prepare the drawer front Screw 2 metal dowels into the drawer front Note: Tighten the metal dowels up fully against the panels.
Page 6
Assembly Instructions Step 4 Fit the drawer base Slide the drawer base down the grooves in the drawer sides and down into the groove in the drawer front Step 5 Fit the drawer back Fit the drawer back between the drawer sides Make sure that the drawer base...
Page 7
Assembly Instructions Step 7 Prepare the left side Finished Screw 8 metal front edge dowels into the left side Place a runner the left side Slide back the top of runner and use the 2nd hole from the front to fit the 1st screw Slide the runner back the other way and...
Page 8
Assembly Instructions Step 8 Prepare the right side Screw 8 metal dowels into the right side Place a runner the right side Slide back the top of runner and use the 2nd Finished hole from the front to fit front edge the 1st screw Slide the runner back the other way and...
Page 9
Assembly Instructions Step 9 Note: The 2 base panels are slightly larger than the top (refer to panels page) Prepare the 2 base panels Insert 4 large locking nuts into each of the 2 bases Note: The arrow on the Finished locking nut must point front edge...
Page 10
Assembly Instructions Step 12 p l a i n c h i p Fit the top a r d s u r f a c Push the top onto the right side Use a screwdriver to Finished tighten the 2 large front edge locking nuts fitted...
Page 11
Assembly Instructions Step 15 Fit the left side Push the left side onto the assembly. Use a screwdriver to tighten the 8 large locking nuts fitted to the top the 2 bases the 2 rails Step 16 The measurement from top corner X to bottom corner X must be equal to the measurement from top corner Y to bottom corner Y Fit the back Square up the unit by...
Page 12
Assembly is complete If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800 and quote the reference numbers on the component pages. Argos Ltd, 489-499 Avebury Boulevard, Central Milton Keynes, MK9 2NW ALR3103...
Need help?
Do you have a question about the San Diego 343/7058 and is the answer not in the manual?
Questions and answers