Table of Contents
Advertisement
I
NSTALLATION
Upon receiving the VWR Incubating/Cooling Shaker, check to ensure
that no damage has occurred in shipment. It is important that any
damage that occurred in transport is detected at the time of unpacking.
If you do find such damage the carrier must be notified immediately.
After unpacking, place the Incubating/Cooling Shaker on a level bench
or table, away from explosive vapors. Secure to a non-movable work
surface by pressing down on the four (4) corners of the unit, creating
a strong suction to the work surface (DO NOT place on a bench mat).
Ensure that the surface on which the unit is placed will withstand
typical heat produced by the unit. Always place the unit on a sturdy
work surface.
The Incubating/Cooling Shaker is supplied with a power cord that is
inserted into the IEC connector on the back of the unit first, then it
can be plugged into a properly grounded outlet. The 120V unit plugs
into a 120 volt, 50/60 Hz source. The 230V unit plugs into a 230
volt, 50/60 Hz source.
M
& S
AINTENANCE
ERVICING
The Incubating/Cooling Shaker is built for long, trouble-free, dependable
service. No lubrication or other technical user maintenance is required.
It needs no user maintenance beyond keeping the surfaces clean. The
unit should be given the care normally required for any electrical
appliance. Avoid wetting or unnecessary exposure to fumes. Spills
should be removed promptly. DO NOT use a cleaning agent or solvent
on the front panel or lid which is abrasive or harmful to plastics, nor
one which is flammable. Avoid cleaning in direct sunlight to prevent
streaking of the polycarbonate lid. Always ensure the power is
disconnected from the unit prior to any cleaning. If the unit ever
requires service, contact your VWR representative.
E
C
NVIRONMENTAL
ONDITIONS
Operating Conditions: Indoor use only.
Temperature:
5 to 40°C (41 to 104°F)
Humidity:
80% relative humidity, non-condensing
Altitude:
0 to 6,562 ft (2000 M) above sea level
Non-Operating Storage:
Temperature:
-20 to 65°C (-4 to 149°F)
Humidity:
max. 80% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with
IEC 664.
2
Advertisement
Table of Contents
