Kolver EDU2AE Manual page 3

IMPORTANT: EDU 2AE and EDU 2AE/HP are highly accurate units but it is critically important to
select the correct options to ensure that proper torque is being applied. Read the menu description
carefully and in case you are unsure please contact Kolver for support information.
Turn the unit on through the on/off switch on the back panel. The unit will go through a general system
check and the words "waiting connection" will appear on the last line of the display. If the connection with
the motor control board is successful the following screen will be displayed:
Press any key on the front panel to enter the main screen (see following picture).
2
P L U T O 1 0
1
J :
1-
Selected type of joint (Hard or Soft)
2- Screwdriver model
3- Screw count: fastened screws/total screws (model EDU 2AE/HP only)
4-
Pre-set torque level (percentage)
5- Selected speed
6- Reached torque level (model EDU 2AE/HP only) in Nm or in.lbs
7- Status bar ( waiting, screwing, errors, etc...)
K o l v e r
E D U 2 A E H P
V e r s i o n
s y s t e m
3
S O F T
Wa i t i n g
To change parameters:
Press the ESC key for 2 seconds.
Select the line by pressing
 will turn into
required value and then confirm through the OK key (or ESC
if you don't want to save the value).
The selected value will be immediately operational, even if
you are still in the menu screen.
Repeat the sequence for all the parameters you wish to change
and then push the ESC key to return to the main screen.
S . R . L .
1 . 0
r e a d y
0 / 0 3 T :
S : 6 0 0 r p m
T : - - -
7
). Press the
M I N
6
or then press OK (the symbol
or key to select the
4
5