Troubleshooting - Logik L714WM12E Installation Instructions Manual

7kg washing machine
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 28

Troubleshooting

Troubles
Washing machine
cannot start up
Water leakage
Water is
overflowed from
the bottom of the
machine
Indicator or
Power is disconnected or the
display does not
unit is turned off.
light
Washing results
are not good
Excessive foam
Excessive amount of detergent
is formed in the
used.
detergent drawer.
As soon as the
machine is filled
The end of water drain hose is
with water, water
too low for the machine.
discharges.
Laundries have
Non-dissolving particles of
detergent
some detergents may adhere to
residues on them.
your laundries as white spots.
Grey spots appear
The reason for these spots may
on the laundries.
be oil, cream or ointment.
*See the "installation" selection of your machine.
Reason
The connection between
water supply hose or drain
hose and tap or washing
machine is not tight.
Drain pipe in the room is
blocked.
The water supply hose is
not connected firmly.
drain hose has water
leakage.
The clothes are too dirty.
Insufficient detergent
quantity.
Solutions
Check that the door is closed tightly.
Check that the power is on.
Check that the water supply tap is open.
Check that the Start/Pause button is
pressed.
Check and fasten water hoses.
Clean up drain hose and ask a qualified
technician to repair it if necessary.
Fix the water supply hose.
Replace the drain hose.
Check that the power is switched on and
the power plug is connected correctly.
Check the mains plug and fuse.
Check that the washing machine is turned
on.
Select an appropriate wash programme.
Add the proper detergent quantity
according to the instructions on your
detergent packaging.
Manually select the Rinse programme. In the
next washing operation, adjust the dose of
detergent as required.
Set the water drain hose end at appropriate
height. (*)
Perform an extra rinse by setting your
machine to the "Rinse" programme, or clean
the spots using a brush after your laundry
dries.
Apply the maximum amount of detergent
instructed by the detergent manufacturer in
the next washing operation. Or use a stain
remover designed for washing machines.
GB
49

Advertisement

Table of Contents
loading

Table of Contents