Attention: Operating the system without the service access cover on for more than 10 minutes
when the system power is turned on might damage the system components.
Figure 18. Removing the service access cover
Removing an NVMe U.2 pass-thru card from the 9009-22G or 9223-22S
system
To remove an NVMe pass-thru card from the system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Lift each air baffle (A) straight up.
See Figure 19 on page 24.
Place air baffles upside down on a clean area. When you turn an air baffle over, hold the detachable
drive cover to prevent it from coming loose.
NVMe U.2 pass-thru card for the 9009-22G or 9223-22S 23