Attention: Operating the system without the service access cover on for more than 10 minutes
when the system power is turned on might damage the system components.
Figure 3. Removing the service access cover
Installing an NVMe U.2 pass-thru card in the 9009-22G or 9223-22S system
To install an NVMe U.2 pass-thru card in the system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Lift each air baffle (A) straight up.
See Figure 4 on page 7.
Place air baffles upside down on a clean area. When you turn an air baffle over, hold the detachable
drive cover to prevent it from coming loose.
6 Power Systems: NVMe U.2 pass-thru cards for the 9009-22G or 9223-22S