ATH-Heinl Cross Lift 35 OG User Manual page 88

6.2 FEEDING OIL AND BLEEDING RUNWAYS
Pay much attention: refill the oil if not enough during this procedure.
After bleeding, make sure to reset ordinary operating conditions. Lift cannot be lifted if a leveling cutoff
cock is opened.
Be sure ADJ/WORK selector
the runway P1 (the master runway: the left side from the view toward the vehicle head) is raised
•
only in this procedure;
b. Keep pressing both the photocell pass-by button and the lifting button to until the runway P1 reaches
the top position;
d. Raise the runway P1 again until it reaches the top position;
e. Set ADJ/WORK selector
g. Press the lifting button to raise the runway P2 (the slave runway: the right side from the view toward
the vehicle head) until the platform reaches the top position. Pay attention to refill the oil;
h. Press the lowering button to lower the runway P2 completely;
i. Repeat raise and lower the runway P2 completely at least 5 times;
j. Raise the runway P2 to the same height as the runway P1;
k. Turn off the leveling cutoff cock 2 and set ADJ/WORK selector into the position "WORK";
l. Lower and raise the runways at least 3 times to check the level of runways. If not leveled, repeat above
procedure.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-11
is set into the position "WORK";
into the position "ADJ";
Manufacturer ATH-Heinl GmbH & CO.KG
- 27 -